|
• Smart Fill Controller uses an upper and
lower sensor to detect the water level in a barrel or container. When
water falls below the level you set, the controller will open the
solenoid, so water fills your container. The solenoid will close when
the water level reaches the top sensor.
•
Two Safety Shutoffs are built into the unit. If the high-water sensor
does not close the solenoid, then a second back-up sensor will close the
solenoid and sound an audible alarm. In addition, if there is a power
outage, the solenoid will close preventing overfilling your container.
• LED Display makes it easy to view power status when your container is filling and when your container is full.
•
Long Cords make it easy to place the sensors in controller in
convenient to use locations. The high and low water sensors each have a 6
½ ft cords and the solenoid has a 9 ½ ft cord.
•
Simple Press Fit connectors make it easy to plumb standard ¼” reverse
osmosis tubing to the solenoid. Water flow directional arrow on top of
the solenoid takes guesswork out of plumbing.
•
Strong Magnets are used to hold the high and low water sensor in the
container of your choice. These magnets work with most plastic and
rubber style containers. The easy finger grips can also be used a cord
router on the outside of your container.
The
Barrel Buddie will monitor the water level at both high and low points
in your barrel or container. When the lower sensor detects the water
level, the low voltage solenoid will open and allow water to flow into
the container. When the water level reaches the upper sensor, the
solenoid will close.
Unlike
float valves or auto top-off systems, the Barrel Buddie reduces TDS
creep by allowing the RO unit to only operate once to fill the
container. This will improve the overall TDS in your collection
container and prolong the life of your DI resin if you are using DI
filtration.
|
Free Ground Shipping on orders over $400.
Restrictions apply*
Quick Order
Shop Brands
New Products
Sales
News
