hygger Aquarium Auto Top-Off Kit is a device that monitors and
automatically adds freshwater to an aquarium to replace the lost water
that the aquarium evaporates. It safely keeps water and salinity levels
(in marine aquariums) stable. With a built-in fail-safe to keep the tank
from overflowing, all functions are displayed by colored LEDs and
warning signals. Ideal for reef aquariums, saltwater aquariums, and
freshwater aquariums.
Auto Filling
When the water level drops below the detection point of the device,
the ATO receives an anhydrous signal, it will automatically control the
water pump to refill water via ‘LOWER LIMIT’. When the water level rises
to the set position, it will auto-stop adding water via ‘UPPER LIMIT’.
Overfill Protection
The ATO system alerts with a flashing LED light and beeping sound if
there is any malfunctioning with the device itself, it uses a top sensor
to sense the high water level, and auto shut off the water pump when
the water level exceeds the desired maximum top-off level.
Dual Fail-Safe Design
hygger auto top-off kit is composed of a controller and a magnetic
suction cup. The magnetic suction cup is installed on the inner side,
and the controller is installed on the outer side. It is aligned with
the water level line that needs to be detected, and then the power is
inserted into the controller and powered on to perform the detection.
Additionally equipped with one external sensor that monitors the
reservoir’s water level to ensure the pump not running dry as a result
of water drying out.
DC-powered Water Pump
Comes with a mini DC-powered water pump and a soft hose that can
effectively pump water from a bucket/jug with a head height of up to 2
meters. the water pump has a max lift of 4.9 ft, make sure the height
from the water pump to the aquarium is not higher than 4.9ft. Vice
versa, it can also drain dirty water out of the tank with a 74 GPH flow
rate.
Keeps Hose in Place
For rimmed or rimless aquariums up to 3/4 inch, make sure the 5.9ft
soft water hose is installed above the water level so it won’t siphon
when the pump cuts off.
External Sensors
Installed an external sensor on the reservoir wall, or put it in the
reservoir if the tank wall is too thick. With a 5.1 ft cable length, the
external sensor should be higher than the water pump, ensuring that the
pump does not burn out as a result of water drying out.
How Does it Work
This auto top-off system adopts double optical sensors and is mainly
used to monitor water shortage and full water status, and control water
pumps and solenoid valves. Specifications
ATO Monitor x 1, magnetic suction cup, for rimmed or rimless aquariums up to 3/4 inch
Water Pump x 1, DC 12 V 5 W, head max: 6.5 FT, flow rate max: 74 GPH |
Package:
1 x ATO monitor sensor
1 x External sensor
1 x Water pump
1 x 5.9 ft soft hose
1 x Hose holder
1 x User Manual |
|
Free Ground Shipping on orders over $400.
Restrictions apply*
Quick Order
Shop Brands
New Products
Sales
News
